/
Loading .ELF file

Loading .ELF file

Owned by edmon.gatchalian@entel.ph
May 26, 2025

  1. Start Entel Digital programmer

  2. Navigate to the taskbar, click on File, then select Load Fleet.

image-20250526-015257.png

  1. Select the file you need to load, then click Open

image-20250526-015650.png

  1. Connect the radio you want to program. Wait for the PC to recognized the radio, the pop-up window (Connected devices) will appear again.

  2. Choose the fleet file to be programmed* and click the write configuration button. Click “Yes” button then click “write configuration anyway” button on the succeeding pop up windows. Wait until the writing is complete before disconnecting the radio from the PC.

image-20241108-092813.png

  1. Repeat steps 4 & 5 for as many radios as you need to apply the programming data to.

*If the radio is only programmed with Analogue channels you should not need to alter the programming file before writing to the new radio. However if the programming file has digital channels you may need to alter the radios ID / add the new radios to the contact list before programming. Wherever possible, this is best done by adding the new radios to the original Fleet File.