/
Adjusting HT Squelch Level

Adjusting HT Squelch Level

  1. Open the Entel Programming software

  2. Place radio into programming mode (press and hold lower side button and power on)

  3. Read radios data

  4. Click on Radio Performance - TRx Tuning

  5. Click Proceed

  6. Select the Rx tuning tab

  7. Using the Squelch level drop down select the level you wish to set

  8. Apply

  9. Write

Radio is now read to test.

 

NOTE: You can also add a Squelch level button in the General & Buttons section.

 

Related content

HT Radio stuck in upgrade mode
HT Radio stuck in upgrade mode
More like this
Add/Remove Model on Entel Programmer v3.2.0.0 / v3.2.0.2
Add/Remove Model on Entel Programmer v3.2.0.0 / v3.2.0.2
More like this
Cannot see / access Talk Permit Tone in Entel Programmer
Cannot see / access Talk Permit Tone in Entel Programmer
More like this
HT FI Loading Error
HT FI Loading Error
More like this
Adding ".dll" file to the Programmer
Adding ".dll" file to the Programmer
More like this
Updating DX or DT firmware using EDP (Entel Dealer programmer)
Updating DX or DT firmware using EDP (Entel Dealer programmer)
More like this